DJI Phantom 4 Foam Insert For Pelican Case 1550
This insert is made of polyurethane foam.
1 Piece Convoluted Lid Foam
1 Piece approximately 5.25" Thick with drone cutout.
1 Piece Polyurethane .50" thick base pad.
#1 & #3 - Misc.
#2 - Controller.
#4 & #6 - 3 Batteries.
#7 - Cables and Accessories.
#8 - iPad up to 9.4" Wide.
#9 - 2 x SD Cards
Also available for these cases:
Pelican Storm iM 2700
Nanuk 945, 950
Seahorse SE-920- $10 Upcharge
For larger cases there will be a up-charge due to the size of the foam.
Over 22" in length - $10 up-charge
Over 30" in length - $20 up-charge
We can also custom make you an insert for your one off case.
If you would like to get more information, please email us with your info at Contact Us.
After receiving the foam insert for my pelican case, I discovered closing the lid took too much pressure. I communicated with the company, and they admitted it was a little tight but the lid would close. I decided to pack it up and send it back. They were very helpful and sent me a packing slip. Too bad it did not fit well.
When I purchased my Phantom 4 drone used, it came with a case without the foam inserts. This product wasi exactly what I was looking for. It fit my equipment perfectly. This is my first experience with Cobra Foam Inserts and I will use them the next time I am in need.
I got this to fit into an older Pelican 1550 case and it has been great. The case itself is a little shorter than I would have liked, but everything fits and is held securely with this insert.
I ordered my foam inserts for my pelican 1550 for my phantom 4 and it dident fit! But I got in contact with cobra inserts and they were quick to correct the error and said they were going to send out new foam for me.
Mistakes happen but they handled it great :)
Despite caution from seller about fit for my Phantom 3 pro, the foam was perfectly cut and presented no problems, considering the small case all that equipment fits into. Highly recommend.